A properly installed interior perimeter drain system intercepts groundwater at the slab edge and routes it to a sump basin before it ever reaches your floor.
Drain tile that isn't sloped correctly is one of the most common installation failures we see when repairing someone else's prior work — water simply pools instead of flowing to the basin. We verify slope with a level, not by eye.
We're licensed and insured for residential and light commercial interior drainage work across Allentown, PA.
Most Allentown, PA inspection requests get a response within a day or two.
Pricing is based on linear footage of drain tile needed, quoted in writing after an in-person measurement.
Every system is tested with a hose before we consider the install complete.
Every Allentown, PA Interior Drainage System job starts with an inspection, not a generic package — here's what that typically includes.
A channel is cut along the slab edge, perforated pipe is laid with proper slope, and gravel backfill allows water to flow freely into the drain.
Every interior drain system needs a sump basin as its endpoint — we size the basin and pump to match the drain tile's expected inflow.
This option works well as a lower-disruption alternative to full perimeter drain tile in certain Allentown, PA basement layouts.
We treat the cove joint as part of every interior drainage install, not as a separate add-on.
We camera-inspect old systems where accessible to determine whether repair or replacement makes more financial sense.
This helps us bring the right materials and estimate linear footage before the visit.
A technician checks where water is entering, measures the perimeter, and identifies the best sump basin location for discharge.
You'll see drain tile footage, basin specs, and any cove joint work broken out in the written estimate.
We test the system with water flow before finishing to confirm proper slope and basin performance.
"Old drain tile from the 1970s had completely silted up. They cleaned what could be saved and replaced the rest."
— Allentown Homeowner
"Cove joint had been the source of our leak for years and nobody had addressed it until now."
— Allentown Customer
"Explained the slope requirements in a way that actually made sense, not just technical jargon."
— Allentown Homeowner
"Sump basin placement was smarter than what a previous contractor had proposed — shorter discharge run, less noise."
— Allentown Customer
Full perimeter systems make sense when multiple walls show signs of intrusion or as preventive coverage.
Drain tile requires cutting the slab; a baseboard channel is a lower-disruption alternative that captures wall seepage without floor demolition.
{Sometimes — if the pipe itself is intact but clogged with silt, cleaning can restore function without a full re-installation.|We camera-inspect where accessible to make that determination before recommending replacement.}
An undersized basin cycles the pump too often, so we don't cut corners on sizing.
Cutting the slab does involve some disruption, but we work in sections and clean up debris as we go.
Most residential installs finish in one to three days depending on perimeter length and whether cove joint sealing is included.
Not sure if your basement needs full perimeter drain tile or a targeted fix? Call +1-866-476-1348 and we'll walk through it.
Zip codes we serve in Allentown, PA: 18104 18101 18103 18102 18109 18001 18105
Call now for a free inspection and a flat-rate quote before anything gets worse.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
